hager SH701AX Notice D'installation page 119

3. A. Remove the battery seal.
B. Press the unlocking button and slide the depleted lithium pack upwards.
C. Wait for 2 minutes and then connect the new lithium power pack inside the relay.
The relay issues a "beep" and the LED lights up green for 2 s.
D. Put the battery seal back in place.
IMPORTANT
• The lithium battery pack must
be replaced with the same type
of pack with the same technical
characteristics, i.e. 2 x
(3.6 V – 17 Ah).
• We advise you to use the
DAITEM MPU01X battery
available in the catalogue
in order to guarantee individual
safety and equipment reliability.
• Dispose of the waste lithium
power pack in an
appropriate
recycling bin.
4. Close the cover and
tighten the 4 screws.
5. Switch the system to user mode using the control panel keypad to enter:
installer code
Li
C
Unlocking button
"beep,
disarmed"
D
A
Li
"beep, disarmed"
B
119