hager SH701AX Notice D'installation page 115

3. Remove the washer, insert it and fix the bracket in place using suitable plugs and
screws.
4. Take the anti-removal magnet
drilling template supplied in the
bag of accessories and insert it
on to the fixing bracket.
5. In compliance with the following
drilling requirements, drill a hole
for the anti-removal magnet using
a suitable 8 mm diameter drill bit.
Hole: Ø 8 mm x 34 mm
6. A. Remove the anti-removal magnet drilling template using a flat-headed screwdriver.
B. Take the magnet and the plug out of the bag of accessories.
C. Put the magnet in the plug.
D. Insert the plug into the hole drilled in step 5.
A
Remove and
dispose of the
unused washer.
B
3.5
C
D
115