hager SH701AX Notice D'installation page 114

5.2.7 Testing the dialler
IMPORTANT: the dialler must be in installation mode (see dialler installation manual).
1. Press the dialler
button for more
than 5 s.
5.2.8 Testing the 8-channel remote relay output receiver
1. Press the 8-channel
remote relay output
receiver "test" button
for more than 5 s. The
LED lights up green.
5.3 Fixing the device in place
1. Loosen the
locking
screw on
the fixing
bracket
and remove
the bracket.
114
2. The control panel issues
the voice message:
2. The control panel issues
the voice message:
Pozidriv 2
"beep, test, dialler X,
relayed"
CONTROL PANEL
"beep, test,
device X, relayed"
2. Mark the 3 fixing points and drill
3. The dialler confirms
control panel reception
by issuing the voice
message:
"beep, control panel"
3. The receiver issues a
long beep to confirm.
"beeep"
the holes using an appropriately
sized drill bit.
DIALLER