hager SH701AX Notice D'installation page 108

3.6 Programming a relayed detector to be recognised by the control panel
IMPORTANT: the relay must be programmed for recognition by the control panel.
"beep"
or
Briefly press Press and hold
the radio the "test" button
repeater relay on the detector
"test" button until the control
panel responds
3.7 Programming a relayed siren to be recognised by the control panel
IMPORTANT: the relay must be programmed for recognition by the control panel. All
transmitter/receiver products (control devices, diallers, 8-channel relay output receivers, etc.)
must be programmed for recognition on the same relay.
"beep"
Briefly press the radio
repeater relay "test"
button
108
"detector X"
10 s max.
As soon as it receives the
order, the control panel
issues a voice message to
indicate the detector n° and
waits for the group (from 1
to 8) to be selected
(depending on the type of
control panel)
The group and type of triggering are selected
10 s max.
Press and hold the "test"
button on the siren until the
control panel responds
"group?"
to
The control panel
waits for the type
of infrared
detection triggering
to be selected:
• 0: immediate,
• 1: delayed,
• 2: combined.
using the control panel keypad.
"beep, siren X
)
)
)
)
)
The control panel issues a
voice message to confirm
relayed siren recognition
programming
"time delay ?"
detector X, group
or or
The control panel
issues a voice
message to confirm
relayed detector
recognition
programming
relayed"
)
)
)
)
)
The siren issues a
long beep to
confirm recognition
programming
"beep,
Y, immediate
(delayed or
combined),
relayed"
"beeep"