Publicité
Les langues disponibles
Les langues disponibles
4. Parameter-setting
4.1 Operating mode change indication
A beep can be issued to indicate each change in system operating status.
To activate or deactivate this feature, use the control panel keypad to enter the following:
relay n°
4.2 Radio anti-tamper protection
The relay monitors availability of the radio links.
If these are purposefully tampered with, the relay sends a radio tamper message triggering
the alerts and deterrents.
To modify radio anti-tamper triggering, use the control panel keypad to enter:
relay n°
4.3 Deactivating the anti-tamper protection against removal
If there is an attempt to remove the device, the relay sends a tamper message triggering the
alerts and deterrents.
To deactivate the anti-tamper protection against removal, use the control panel keypad to
enter:
relay n°
5. Installing the radio repeater relay
5.1 Choosing the best place to install the relay
The relay can be installed:
• inside,
• outside but in a location sheltered from the weather,
• making sure there is a distance of at least 2 metres between each product, except
between two detectors,
• at a height above 1 m from the ground and clear of any obstacles (furniture, metallic
structures, etc.),
• far away from possible sources of electrical disturbance (electricity meter, telephone
cabinet, etc.).
The receiver cannot be installed: directly on a metallic surface,
0: disabled
1: enabled (factory)
0: disabled (factory)
1: enabled (configuration necessary to comply with EN50131-3)
0: anti-tamper enabled (factory)
1: anti-tamper disabled
111
Publicité
