hager SH701AX Notice D'installation page 105

Product recognition programming must be performed according to the order below:
• relay programming for recognition by the control panel,
• relayed product recognition programming.
The relayed product must
be programmed for
recognition by one relay
only. It cannot be
programmed again for
recognition by another relay.
All transmitter/receiver
products (control devices,
diallers, 8-channel relay
output receivers, etc.)
must be programmed for
recognition on the same
relay.
Several relays cannot
be cascaded.
A remote control can be
programmed for recognition
by a control panel via a relay
but can also operate directly
via the control panel.
)
)
)
)
)
)
)
)
)
)
)
)
)
)
)
Recognition
programming
on a 2 relay
nd
impossible
Recognition
programming
on a 2 nd relay
impossible
)
)
)
)
)
)
)
)
)
)
105