hager SH701AX Notice D'installation page 104

2. Remove the pre-cut part of the
guarantee sticker and stick it to
the guarantee certificate in the
user manual supplied with the
control panel. If you are adding
to an existing system, use the
guarantee certificate supplied
with this product.
3. Connect the lithium power pack to its base.
The relay beeps and the LED lights up green for 2 s.
3. Recognition programming
IMPORTANT:
• During recognition programming, the product to be programmed for recognition does not
need to be close to the control panel. In fact, it is advisable to move it at least 2 metres away.
• The control panel issues three short beeps to indicate an error. When this happens, perform
recognition programming again from the start.
3.1 Introduction to recognition programming
Recognition programming enables the relay and other products to recognise each other.
A product can be: • directly linked to the control panel via radio,
If a product has to be relayed, it must be programmed for recognition by the control panel
via the relay. Otherwise, it must be programmed for direct recognition by the control panel
(see Control panel installation manual).
104
• or relayed.
SH701AX
A1250A04823
SH701AX
Coller sur certif
A1250A04823
LED
Test button
SH701AX
A1250A04823
SH701AX
Coller sur certif
A1250A04823
IMPORTANT: the LED
flashes red every 2 s. if
the anti-removal magnet
system has not been
properly installed (see
chapter 5.3 Fixing the
device in place).