Publicité
Les langues disponibles
Les langues disponibles
3.10 Checking recognition programming
Enter the following on the control panel keypad:
The panel reads out the list of products programmed for recognition and specifies whether
they are relayed or not.
Example:
3.11 Deleting a product programmed for recognition
IMPORTANT: if the radio repeater relay is deleted, this does not mean that all the relayed
products are automatically deleted. Each product's recognition programming must be deleted
on the control panel.
To delete a recognised product, enter the following using the control panel keypad:
Example: to delete the 2
programmed, enter:
3.11.1 Following deletion
To restore a direct link between a product and the control panel, the product must be
programmed for direct recognition (see chapter on Recognition programming in the control
panel manual).
To relay a product programmed for direct recognition by the control panel, recognition
programming via the relay must be performed, as described above.
To change a relay product
When changing a relay or removing a relayed product, make sure you:
• delete its recognition programming,
• programme the product for recognition via the new relay.
3.11.2 Returning to relay factory configuration
• Connect the lithium power pack and press on the test button at the same time.
• Hold the button down until you hear a beep.
• Release the button and a long beep is issued to confirm relay factory configuration.
110
"beep, control unit 1,
beep, detector 1, group 2,
immediate, relayed,
beep, siren 1"
type of
product
product
n°
control device
nd
Type of product
Detector
Control unit
Siren
Dialler
Radio repeater relay
or 8-channel relay output receiver
N°
2
3
4
5
7
Publicité
