hager SH701AX Notice D'installation page 116

7. Put the seals on the relay.
IMPORTANT: to guarantee relay weather
resistance, you must position and block all
seals in their slots making sure they are
mounted the right way round.
9. Lock the base using the locking screw. The LED will
stop flashing red indicating that the anti-removal
magnet has been properly positioned. If this is not the
case, perform steps 4 to 6 again.
10.
IMPORTANT: to meet
the requirements of
EN 50130-5 class III,
insert a seal between
the base and the
battery in order to
block the battery.
116
8. Hook the base on to the fixing
bracket.
Œ
Pozidriv 2
