hager SH701AX Notice D'installation page 117

11. Close the cover and
tighten the 4 screws.
6. Switching to user mode
1. Switch the system to user mode using the control panel keypad to enter:
installer code
2. Put the control panel cover back.
7. Performing a real test
Test each relayed product (see the installation manual for each relayed product).
Pozidriv 2
Pozidriv 2
IMPORTANT: if the control panel issues the voice
message "beep, fault, anti-tamper, device X", check that
the anti-removal magnet is positioned properly (steps 4
to 8 in chapter 5.3) and the cover is closed.
117