hager SH701AX Notice D'installation page 106

3.2 Programming a relay to be recognised by the control panel
IMPORTANT: the relay and control panel must be in installation mode. The relay is in
installation mode when powered. Please refer to the installation manual for the control panel.
Open the control panel cover and proceed as follows:
"beep"
Briefly press the radio
repeater relay "test"
button
3.3 Programming a relayed remote control to be recognised
by the control panel
IMPORTANT: the relay must be programmed for recognition by the control panel. All
transmitter/receiver products (control devices, diallers, 8-channel relay output receivers, etc.)
must be programmed for recognition on the same relay.
"beep"
Briefly press the radio
repeater relay "test"
button
106
"beep, disarmed,
control panel"
)
10 s max.
Press and hold the
"Off" button on the
control panel until the
panel responds
)
10 s max.
Press and hold the "Off"
button on the remote
control until the control
panel responds
"beeep"
)
)
)
)
The radio repeater relay
issues a beep to validate
recognition programming
"beep, control
unit X relayed"
)
)
)
)
The control panel issues a
voice message to confirm
relayed remote control
recognition programming.
"beep, relay X"
)
)
)
)
)
The control panel issues
a voice message
indicating the radio
repeater relay n°
)
)
)
)
)
The remote control LED
lights up a steady green for
1.5 s to confirm recognition
programming.