Stihl SR 430 Notice D'emploi page 11

4 Adjusting the Throttle Cable
4
5
5
► Push the hose clamp (3) onto the pleated
hose (2).
► Line up the marks on the hose clamp (3) and
elbow (4) – as shown.
► Secure the hose clamp (3) with the screw (5) –
make sure the antistatic wire is located in the
notch.
3.5 Adjusting and securing the con‐
trol handle
► Put the machine on your back and adjust the
harness – see "Harness".
1
► Slide the control handle (1) along the tube to
the most comfortable position – distance
between nozzle outlet (2) and the control han‐
dle (1) must be at least 500 mm ('a').
0458-454-8221-F
3
2
4
3
a
► Secure the control handle (1) with the screw
(3).
► Use the retainer (4) to secure the hose and
throttle cable, and metering unit's operating
cable on the SR 450, to the 6th pleat (arrow)
on the pleated hose.
4 Adjusting the Throttle
Cable
It may be necessary to correct the adjustment of
the throttle cable after assembling the machine
or after a prolonged period of operation.
Adjust the throttle cable only when the unit is
completely and properly assembled.
2
► Set throttle trigger to the full throttle position –
as far as stop.
► Carefully rotate the screw in the throttle trigger
in the direction of the arrow until you feel initial
resistance. Then rotate it another full turn.
1
3
4
English
11