Stihl SR 430 Notice D'emploi page 22

English
► Hook the lever (3) over the bar (5) on the solu‐
tion container.
3
6
► Press the levers (3) down until the tabs (2)
snap into their seats (6) on the housing with a
loud click.
► Check that the container is firmly seated.
Blower tube
1
► Insert a screwdriver into the tab (1) of the hose
clamp (2) on the control handle.
22
5
6
6
2 2
2
3
► Turn the screwdriver clockwise to loosen the
hose clamp (2).
► Pull the hose (3) off the stub.
► Rotate the nozzle (4) until the lugs (5) are cov‐
ered.
► Pull the nozzle (4) off the blower tube (6).
13.4 Converting back to misblowing
mode
3
The conversion is carried out in the reverse
sequence.
Fitting the hose
► Push the hose with clamp (2) over the stub on
the control handle.
► Use pliers to squeeze the hose clamp
together (2) until the retaining strip engages
and locks.
14 Filling the Container
1
► The gasket (1) in the cap must be in good con‐
dition, lubricated with grease and clean.
14 Filling the Container
4
6
5
2
0458-454-8221-F