Gima SP-20 Mode D'emploi page 52

4.3.3 Recording Mode
On main menu screen, move the cursor on
"Recording Mode" and press Confirm key
" ", then the oximeter enters into Re-
cording Mode Setup screen, as shown in figure
4.6.
Figure 4.6 Recording mode setup screen
Note: When selecting "Spot-check Record" for data recording, the measuring time
should last over 10 seconds to get one spot-check reading, or no reading value will
not be recorded in Spot-check data record; When selecting "Trend Record", the
measuring time should exceed 30 seconds, or no one record will be recorded in Trend
data record list.
4.3.4 SpO Record
2
On main menu screen, move the cursor on "SpO
" ", then the oximeter enters into SpO
as shown in figure 4.7.
Figure 4.7 SpO2 record review method selecting screen
Refer to Section 4.4 for details.
4.3.5 TEMP Record
On main menu screen, move the cursor on "TEMP Record" and press Confirm key
" ", then the oximeter enters into temperature record list screen, as shown in
figure 4.8.
ENGLISH
Record" and press Confirm key
2
record review method selecting screen,
2
52