Publicité
9 - Installation
9.1 Unpacking
WARNING!
The appliance is heavy. Always handle with at least two persons.
Keep all packaging materials out of childrens reach and dispose them in an environ-
mentally friendly manner.
Take the appliance out of the packaging.
Remove all packaging materials.
9.2 Environmental conditions
The room temperature should always be between 10 °C and 38 °C, since it can influence
the temperature inside the appliance and its energy consumption. Do not install the appli-
ance near other heat-emitting appliances (ovens, refrigerators) without isolation.
9.1
W1
D1
W2
9.2
10 cm
10 cm
10 cm
9.3
max 45°
1.
3.
22
9.3 Space requirements
Required space to open the door (Fig. 10.1):
D4
Width
in mm
D2
D3
W1 W2 D1 D2
545
545
FOR a free standing appliance: this refrigerating
10 cm
appliance is not intended to be used as a built-in
appliance.
10.4 Ventilaton cross-section
safety reasons, the information of the required ventila-
tion cross sections must be observed (Fig. 10.2).
10.5 Aligning the appliance
The appliance should be placed on a at and solid sur-
face. If the appliance is placed on a pedestal, strong and
2.
foam packing material as a pedestal.
1. Tilt the appliance slightly backwards (Fig. 10.3).
2. Set the feet to the desired level.
3. The stability can be checked by alternately bump-
ing on the diagonals. The slight swaying should be
the same in both directions. Otherwise the frame
can warp; possible leaking door seals are the result.
A low tendency to the rear eases the closing of the
door.
Depth
in mm
D3
838 480 968 1046
838 500 988 1066
Distance to wall
Model
in mm
identifier
D4
CUQS
100
58EW*
CUQS
100
513EW*
EN
Publicité
