Scheppach HS 720 Traduction Des Instructions D'origine page 31

20. Saw blade replacement
1
Wait until stationary and allow to cool down. Pull
out the mains plug or disconnect the spark plug
connector!
• The saw blade can only be replaced in the firewood
cutting position.
• Loosen the top and bottom screws on the protec-
tive cover approx. 5 mm and open the protective
cover.
• To lock the saw blade into place, insert the locking
pin (1) through the corresponding opening on the
saw blade guard. To do this, insert the pin com-
pletely and straight into the hole. Use the corre-
sponding hole (depending on the saw blade type)
so that the pin is at the lowest point (bottom of the
tooth).
• Loosen the saw blade with the supplied open-end
spanner / Allen wrench (2).
• Remove saw blade flange and saw blade
• Insert the new saw blade.
• Mount the saw blade flange again and tighten the
clamp screw.
• Remove the locking pin.
m Attention! When inserting the saw blade,
make sure the running direction is correct!
2
www.scheppach.com
GB | 31