Scheppach HS 720 Traduction Des Instructions D'origine page 27

m WARNING
Always only use a safety petrol canister. Do not smoke when filling petrol. Remove any oil or petrol residues.
Switch the engine off before filling petrol and let the engine cool for several minutes.
Please also read the enclosed operating manual for the petrol engine!
13. Commissioning
• Observe the safety instructions before the commissioning.
• All safety devices and aids must be installed.
• Check the swivel frame; it must return to the starting position by itself. Check that the saw blade is properly seated and
that the running direction is correct.
• Function test before starting work.
• To start up the saw, press the on/off switch.
• The saw is designed exclusively for cross-cutting firewood with a maximum length of 1 metre.
• Regardless of the wood diameter, only one piece with a min. Ø 60 mm may be placed on the swivel frame.
• With both hands on the handle, swivel the swivel frame towards the saw blade.
• Then bring the swivel frame into the starting position.
• The wood to be sawn must not be fixed by hand.
• After the saw has come to a complete standstill, pull out the mains or spark plug connector.
• Only carry out modifications, setting, measuring and cleaning work when the engine is switched off. Wait until the rotat-
ing tool has come to a standstill and remove the mains plug / spark plug connector.
Starting the engine
Follow the procedure below for cold starting:
1. Turn the fuel valve (B) to the right to the
open position.
2. Turn the choke lever (A) on the engine
fully to the left, to the "ON" position.
3. Set the throttle lever (C) to the half-open
position.
4. Turn the ignition switch (E) to ON.
5. Pull the recoil starter handle (D) slow-
ly several times so that the petrol flows
into the carburettor. Then hold the recoil
starter handle (D) and pull the cord out a
little until you feel resistance. Then pull
the cord out in one quick movement and
let the cord wind up again slowly. Do not
let the cord recoil. If necessary, pull the
recoil starter handle (D) several times
until the engine starts.
6. Let the engine warm up for a few seconds. Then gradually move the choke lever (A) to the right to the "OPEN" position.
Restarting an engine that is already warm from previous operation does not normally require the use of the choke.
1. Turn the fuel valve (B) to the right to the open position.
2. Set the throttle lever (C) to the half-open position.
3. Turn the ignition switch (E) to ON.
4. Then hold the recoil starter handle (D) and pull the cord out a little until you feel resistance. Then pull out the recoil
starter handle (D) in one quick movement and let the cord wind up again slowly. Do not allow the recoil starter handle
(D) to recoil.
After the engine has started, move the throttle lever (C) to the full throttle position so that the saw blade can reach its
maximum speed.
End of work
• Slowly move the throttle (C) to the stop position.
• Close the fuel shut-off valve (B).
A
B
www.scheppach.com
C
D
E
GB | 27