Motorola DTR600 Mode D'emploi page 49

3 For the Source Radio, perform the following actions:
a Press the Menu/
OK→Advanced→Cloning→Radio Cloning
b Place the Source Radio in its SUC.
c Press the Menu/OK button.
The display shows Cloning....
If successful:
• The display shows Cloned Successfully.
If unsuccessful:
• The display shows Cloning Failed.
4 After completing the cloning process, exit the
'cloning' mode by long pressing the Home/Back
button.
7.5.3
Troubleshooting Cloning Mode
In the event that cloning fails, perform each of the following
steps before attempting to start cloning process again.
1 Ensure that the batteries on both radios are fully
charged and engaged properly on the radio.
2 Check the cloning cable connection on both Single-
Unit Chargers (SUC).
3 Ensure that there is no debris in the charging tray
or on the radio contacts and the radio contact
is touching the SUC or Multi-Unit Charger (MUC)
contact firmly.
4 Ensure that the target radio is turned on.
5 Ensure that the source radio is in cloning mode.
English
49