Motorola DTR600 Mode D'emploi page 64

English
Troubleshooting
The following table explains the ways to troubleshoot if the
symptom occurs.
11.1
Troubleshooting
Troubleshoot your radio using the method described in the
table.
Table 17: Troubleshooting
If... Then...
If there is no recharge or replace the Li-ion bat-
power, tery.
If Customer perform one of the following actions:
Programming
64
NOTE:
Extreme operating tem-
perature may affect bat-
tery life. See Battery
Specifications on page
15.
If... Then...
Software (CPS)
• Ensure that one side of the pro-
is unable to
gramming cable is connected to
read the radio,
the radio,and the other side of
the programming cable is con-
nected to the USB port.
• Verify that the switch on the pro-
gramming cable is set at Digital
position or Flash position in old-
er version programming cable.
• Ensure that the radio is posi-
tioned correctly inside the Sin-
gle-Unit Charger (SUC).
If the radio gen- press the PTT button again when
erates continu- receive mode ends.
ous tone when
pressing the
PTT button,
If the radio does perform one of the following actions:
not transmit au-
• Verify that nobody else is using
dio when press-
the channel and try again.
ing the PTT but-
ton,