Motorola DTR600 Mode D'emploi page 65

If... Then...
• When using an earpiece, ensure
that the PTT button is disabled.
• Ensure to use the earpiece in-
line with PTT button to transmit.
If you receive customize your PROFILE ID to a 4-
communication digit number for all radios.
that is not within
your channel,
If you hear a perform one of the following actions:
cracking noise
• While wearing the radio on belts
when nobody is
or pockets, check if the PTT but-
talking,
ton is not against another object.
• Use earpiece.
If the audio perform the following actions:
quality is not
1 Check if the radio settings are
good,
the same in all radios.
2 Go to Advanced Configuration
Mode.
3 Adjust the microphone sensitivity
gain (MIC Gain).
If... Then...
For more information, refer to
vanced Settings on page
If the audio ensure that you are within transmis-
sounds garbled/ sion range.
robotic,
If the transmit- hold the radio vertically 1 inch to 2
ted audio is low, inches from your mouth when talk-
ing.
For accessory, hold the accessory
microphone 2 inches to 3 inches
from your mouth when talking.
English
Ad-
44.
NOTE:
Digital technology gives
you the advantage to ex-
perience clear audio up
to the edge of the range.
However, when maximum
transmission range has
been reached, audio may
sound garbled just before
the transmission is lost
completely.
65