Checchi & Magli WOLF Manuel D'installation Et D'entretien page 58

Hitching and unhitching the work vehicle to and from the tractor
Danger - Warning
Hitching the work vehicle up to the tractor is one of
the riskiest moments as it could required the involve-
ment of several people at once, carrying out synchro-
nised manoeuvres between the tractor driver and the
operators on the ground, which - if badly organised -
could result in accidents.
The work vehicle must only ever be coupled to a
tractor with an appropriate power rating which is
equipped with a lift that complies with the regula-
tions in force, observing the maximum weight limit
on the rear axle and the gross vehicle weight (see
tractor user manual).
Check that the work vehicle coupling to the tractor at
the third point of the hitch is securely locked so that
it cannot work loose.
For hitching, proceed as outlined below.
1) Position the work vehicle on flat, solid ground in a
risk-free area.
2) Move the tractor so that it is positioned near the work
vehicle lift frame.
3) Align the arms of the lifting unit with the coupling
points on the work vehicle.
4) Switch off the tractor engine and remove the key
from the ignition.
M
UN41 0089GF
English language
INFORMATION FOR USE
L
A A
N
5) Turn the tie rods (A) to adjust the height of the lift
arms (B) (see tractor instruction manual).
6) Insert the pins (C) into the lift arms and fit in the lock
pins (D).
7) Turn the tie-rod (E) to adjust the space between the
tie-rod and the upper coupling (F) of the support
frame.
8) Insert the pin (G) and the lock pin (H).
9) Remove lock pin (L), slide out pin (M) and lift the rest-
ing foot (N) off the ground.
10) Adjust the tie-rod (E) so that the work vehicle is paral-
lel with the ground.
For unhitching, proceed as outlined below.
1) Select an area with flat, solid ground to park the work
vehicle - tractor.
2) Using the tractor's controls, lower the work vehicle to
the ground.
3) Lower the resting foot (N), insert pin (M) and lock pin
(L).
4) Switch off the tractor engine and remove the ignition
key from the dashboard.
5) Take out the lock pin (H) and remove the pin (G).
6) Slide out the lock pins (D) and remove the lift arms
(B) from the work vehicle's coupling points.
E
G
21
H
F
C
Use and maintenance
6
D
B