ANT Timex W-248 Mode D'emploi page 9

W248_EU_EN.qxp _TMX_M632 10/5/09 11:11 AM Page 10
To Use Your Heart Rate Monitor
1. Wet thoroughly the Heart Rate sensor pads under
running tap water (2-3 seconds per pad). If necessary,
use a heart rate monitor electrode gel for better
contact.
2. Center the Sensor on your chest with the Timex
facing up and out and fasten it firmly, just below your
sternum.
3. Press the MODE button until your desired mode appears. You can view
heart rate information in Time of Day, Chrono, Interval Timer, or Timer
Modes.
4. Press the HEART RATE button on your watch. The antenna icon will
appear on the display indicating the watch is searching for a signal
from the Heart Rate Sensor. When the watch begins receiving a signal,
a pulsing heart icon will appear on the display. In certain modes, the
watch will automatically search for a Heart Rate Sensor when you
enter the mode.
NOTE: The watch automatically records your heart rate and other
statistical data about your workout (available in Review Mode) when
you use Chrono and Interval Timer Modes.
5. Press the START/SPLIT button and begin your workout.
6. If the watch is set to alert you when you go above or below your
10
All manuals and user guides at all-guides.com
® logo
chosen target heart rate zone press and hold HEART RATE to turn the
audible alert off. Otherwise it will continue beeping until you return to
your target zone. When you are turning the audible alert off, you will
see the message HOLD FOR ALERT OFF. Conversely, when turning the
audible alert on, you will see the message HOLD FOR ALERT ON.
7. When you have finished your workout, press the STOP/RESET/SET
button to stop recording data for the workout if you are using Chrono
or Interval Timer Modes.
8. Remove the Heart Rate Sensor from your chest and the watch will stop
recording further heart rate data in approximately one minute.
9. Press MODE until you see Review Mode. This Mode includes heart rate
and other statistical data about your workout. See pages 37 to 40 for
more information about Review Mode.
NO HRM DATA Message
If the watch is not receiving heart rate information, you may receive the
message NO HRM DATA on the watch display. Try the following:
Shorten the distance between the watch and the Heart Rate Sensor.
Adjust the position of the Heart Rate Sensor and elastic chest strap.
Make sure the Heart Rate Sensor pads are wet or use conductive gel.
Check the battery in the Heart Rate Sensor and replace it if necessary.
Move away from other heart rate monitors or other sources of radio or
electrical interference.
11