ANT Timex W-248 Mode D'emploi page 20

W248_EU_EN.qxp _TMX_M632 10/5/09 11:11 AM Page 32
2. Press START/SPLIT to start the timer countdown. The hourglass icon
will appear on the display.
3. Pause the countdown by pressing STOP/RESET/SET.
4. Resume the countdown by pressing START/SPLIT again or reset the
timer by pressing and holding STOP/RESET/SET again until the words
HOLD TO RESET briefly appear on the display followed by the original
countdown time.
5. When the timer reaches the halfway point (if HALFWAY ALERT is set) a
brief chime will sound.
6. When the timer reaches zero, an alert will sound. Press any button to
silence the alert.
7. The timer will stop after the alert if set to STOP; or
The timer will begin another countdown if set to REPEAT and continue
until you press STOP/RESET/SET. The display will show REP and a
number (for example, REP 2). REP indicates the timer is repeating and
the number indicates how many times the timer has cycled through
the repeat countdown. You will also see the repeating hourglass
I
icon , indicating the timer is set to repeat.; or
The timer will switch to Chrono Mode if the chronograph is off and
cleared. You will see the stopwatch icon
switch modes at the end of the countdown and the hourglass icon
indicating the timer is operating.
32
All manuals and user guides at all-guides.com
H
W
indicating the timer will
H
Timer Mode Notes & Tips
You can press MODE within Timer Mode to switch the display to
another mode without disrupting the operation of the timer. The
H
hourglass will continue to display to indicate the timer is operating.
When you use the halfway alert the watch will beep when you have
reached the halfway point of the set countdown time.
With the timer running along with the Heart Rate Sensor, you can
change the Timer Mode display by pressing HEART RATE. Choose from:
1. Heart Rate/Countdown Time;
2. Countdown Time/Heart Rate;
3. Heart Rate only; or
4. Countdown Time (and a repeat number if set to REPEAT).
33