ANT Timex W-248 Mode D'emploi page 19

W248_EU_EN.qxp _TMX_M632 10/5/09 11:11 AM Page 30
Timer Mode allows you to set a fixed time from which the watch counts
down to zero (i.e., 10, 9, 8, ...). In addition you can set the watch to repeat,
stop or switch to Chrono Mode at the end of the countdown (if the
chronograph is off and cleared) and alert you when you are halfway
through a timing sequence.
INDIGLO ® BUTTON
Press to light the watch,
activate/de-activate the
®
Night- Mode feature.
MODE
Press to move to the
next mode, digit, setting
option, or group.
START/SPLIT
Press to begin timing,
continue timing after a
pause, or increase or
toggle a setting item.
NOTE: You can press any button in Timer Mode to silence the alert that
sounds when the timer reaches zero.
To Set the Timer
1. Press MODE until TIMER appears.
30
All manuals and user guides at all-guides.com
Timer
STOP/RESET/SET
Press to start or complete
the setting process, pause
or stop the timer, or clear
data.
HEART RATE
Press to switch display
views or decrease or
toggle a setting item.
2. Press STOP/RESET/SET until TIMER SET then SET briefly appear on the
display followed by the timer with the hours value flashing.
3. Press START/SPLIT (+) to increase or toggle the values or HEART RATE
(-) to decrease or toggle the value. This applies for hours, minutes,
seconds, end action, and halfway alert.
NOTE: The end action setting allows you to choose how the timer
operates at the completion of a timing countdown. Options include
STOP, REPEAT, or CHRONO. If you choose CHRONO, the watch
automatically switches to Chrono Mode at the end of the countdown
(if the chronograph is off and reset to zero) and begins operating the
chronograph.
NOTE: To quickly change the value being set, press and hold
START/SPLIT (+) or HEART Rate (-).
4. Press MODE (NEXT) to move to the next value for hours, minutes,
seconds, end action, and halfway alert.
5. Press STOP/RESET/SET (DONE) to save your changes and exit the
setting process.
To Operate the Timer
1. Press and hold STOP/RESET/SET to clear data from any previous use
of the timer (if necessary). You cannot start another countdown without
resetting the timer.
31