Monogram ZIC363IPVLH Instructions D'installation page 66

Installation Instructions - Door Panels - French Door Models
3/4" CUSTOM DECORATIVE PANELS
The custom panel must be 3/4" (1.91cm) thick. Brackets
are included with the refrigerator to provide mounting to
the appliance door.
NOTE: We recommend that decorative panels have
inside corners and edges rounded or beveled by cabinet
maker to avoid sharp edges on the panels. Edges to be
treated should include the top, bottom and hinge side
edges.
NOTE: The back side of the panel is recommended to
be finished. Portions of the back side of the panel will be
visible when the door is open.
NOTE: For panels constructed with rails and stiles
(5-panel) the rails must be a minimum of 3" wide and the
stiles must be a minimum of 4.5" wide.
STEP 1 PANEL PREP
Custom Panels:
1. Verify overall panel dimensions match the dimensions
supplied in Appendix A. Inspect panels for any initial
damage.
2. Templates are provided with the unit to assist in
drilling the pilot holes in the correct locations. An
additional copy of the templates are included in
Appendix B.
3. Follow instructions on templates for drilling pilot holes
and installing brackets. Panel brackets are shipped
with the refrigerator in the convertible drawer.
4. Use #6 phillips head wood screws provided with
refrigerator to install brackets. Do not tighten screws.
5. Install the handles being sure all hardware mounts
below the back surface of the panel.
Stainless Steel Panels:
1. Panel brackets are shipped with the refrigerator in
the convertible drawer. Use the M4 machine screws
provided with the stainless steel panel kit to install
brackets. Do not tighten screws.
2. Install Monogram Statement or Minimalist handles
(sold separately). Follow instructions provided in the
handle kit.
IMPORTANT NOTE:
Maximum panel weights
Top Panels - French Door
(refrigerator)
Middle Panel (convertible)
Bottom Panel (freezer)
Dimensions can be found in Appendix A: Custom
Decorative Panel Dimensions.
J1 H1
D1
Right
Top Panel Top Panel
*
G1
E1
* *
H1
J1
Middle Panel
F1
D1
Bottom Panel
E1
French Door
Rear View of Panels
Do not tighten the screws, you will do
that after assembly process and left
to right alignment.
66
20.7 lb. (9.4 kg)
7.5 lb. (3.4 kg)
17.1 lb. (7.5 kg)
Use a small washer
for each screw when
installing J1 and H1
A1
brackets.
Left
*
G1
* G1 brackets along with the
bottom H1 and J1 brackets
will be installed after door
panels are hung.
B1
C1
A1
B1
31-1000708 Rev. 0