Monogram ZIC363IPVLH Instructions D'installation page 61

Installation Instructions - Door Panels - Single Door Models
3/4" CUSTOM DECORATIVE PANELS
The custom panel must be 3/4" (1.91cm) thick. Brackets
are included with the refrigerator to provide mounting to
the appliance door.
NOTE: We recommend that decorative panels have
inside corners and edges rounded or beveled by cabinet
maker to avoid sharp edges on the panels. Edges to be
treated should include the top, bottom and hinge side
edges.
NOTE: The back side of the panel is recommended to
be finished. Portions of the back side of the panel will be
visible when the door is open.
NOTE: For panels constructed with rails and stiles
(5-panel), the rails and stiles must be a minimum of 2"
(5.08cm) wide.
STEP 1 PANEL PREP
Custom Panels:
1. Verify overall panel dimensions match the dimensions
supplied in Appendix A. Inspect panels for any initial
damage.
2. Templates are provided with the unit to assist in
drilling the pilot holes in the correct locations.
3. Follow instructions on templates for drilling pilot holes
and installing brackets. Panel brackets are shipped
with the refrigerator in the convertible drawer.
4. Use #6 phillips head wood screws provided with
refrigerator to install brackets. Do not tighten screws.
5. Install the handles being sure all hardware mounts
below the back surface of the panel.
Stainless Steel Panels:
1. Panel brackets are shipped with the refrigerator in
the convertible drawer. Use the M4 machine screws
provided with the stainless steel panel kit to install
brackets. Do not tighten screws.
2. Install Monogram Statement or Minimalist handles
(sold separately). Follow instructions provided in the
handle kit.
31-1000708 Rev. 0
IMPORTANT NOTE:
Maximum panel weights
Top Panel - Single Door
(refrigerator)
Middle Panel (convertible)
Bottom Panel (freezer)
Dimensions can be found in Appendix A: Custom
Decorative Panel Dimensions.
Bracket Locations
D1
Top
*
G1
Panel
E1
Middle
F1
Panel
D1
Bottom
E1 Panel
Single Door
Rear View of Panels
Do not tighten the screws, you will do
that after assembly process and left
to right alignment.
61
39.1 lb. (17.7 kg)
7.5 lb. (3.4 kg)
17.1 lb. (7.5 kg)
A1
*
G1
* G1 brackets to be installed
after door panels are hung.
B1
C1
A1
B1