Monogram ZIC363IPVLH Instructions D'installation page 16

Installation Instructions - Single Standard Installation
STEP 8 LEVEL UNIT
All models have 4-point leveling. The front is supported
by leveling legs; the rear is supported by adjustable
wheels. Both are accessible from the front of the unit.
To level the back of the unit, turn the 7/16" hex nut
located above the front leveling legs. Turn clockwise
to raise or counterclockwise to lower the unit.
leveling leg or a 7/16" open-end wrench at the bottom
of the leveling leg.
opening 84". The unit should be level and plumb with
cabinetry.
7/16" hex nut
adjusts rear
wheels
T30 bit
adjusts front
leveling legs
NOTICE: The rear leveling wheels and front leveling
legs are limited to a maximum height adjustment of 1".
If the installation requires more than 84" height, the
installer should elevate the unit on a sheet of plywood
or runners. Cabinetry trim could also be added across
the top of the opening to shorten the opening. If you
attempt to raise the unit more than 1", you will damage
the front leveling legs and the rear leveling wheels.
STEP 9 FINAL EXTERNAL UNIT
PREPARATION
removal tool. Filter
Compartment Door
should be as shown.
Filter Removal
Tool
counterclockwise
tool if needed).
to remove. NOTE:
Water system will not
place.
7/16" open end
wrench adjusts
front leveling legs
Filter
Mounting Hook
STEP 9 FINAL EXTERNAL UNIT
PREPARATION (Cont.)
Predrill 1/16" holes is both the sides of the surround
1/2" deep through holes in the enclosure.
Secure unit by driving four 1/4" hex screws to both
sides to surrounding cabinetry. NOTE: This step
does NOT replace the anti-tip safety hardware.
Refer to Step 4 Installing Anti-Tip Bracket and Step
7 Inserting/Securing into Cabinet Surround for
details on installing the anti-tip hardware. For dual
installations, repeat for the second unit.
as shown.
Close the compartment door.
Put the access cover back onto the unit and secure
with two 1/4" hex head screws.
Access
Cover
16
1/4" Hex Screws
1/4" Hex
Screws
31-1000708 Rev. 0