Monogram ZIC363IPVLH Instructions D'installation page 20

Design Guide - Single Integrated Installation
SINGLE INTEGRATED INSTALLATION SPACE
Dimensions in parentheses are in centimeters.
84" (213.4)
Product Clearances
These units are equipped with a 2-position door stop.
The factory set 115° door swing can be adjusted to 90° if
clearance to adjacent cabinets or walls is restricted.
Refer to Dim A on page 6 for clearances needed for door
swing.
Water And Electrical Locations
Electrical and water supply must be located as shown.
The Cutout Depth Must Be 25".
36" (91.4)
9"
18"
(22.9)
(45.7)
8" 9"
(20.3) (22.9)
ELECTRIC WATER 6" (15.2)
6" (15.2)
Finished
Return on both
sides and top
* For installation spaces deeper than 25", it is
2 1/2" (6.4)
recommended to install a spacer block per the
Additional Specifications
A 115 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch circuit
or circuit breaker is recommended. Install a properly
grounded 3-prong electrical receptacle recessed into
the back wall. Electrical must be located on rear wall
as shown.
The water line should be 1/4" O.D. copper tubing or
QuickConnect™ kit (WX08X10006) between the cold
water line and water connection location, long enough
to extend to the front of the unit (8' [2.4 m]). Installation
of an easily accessible shut-off valve in the water line
is required.
matching cabinet exterior is recommended on
interior on all sides and top at front of opening.
20
25" (63.5)
24 7/8"
(63.2)*
80"
(203.2)*
dimensions shown.
31-1000708 Rev. 0