Monogram ZIC363IPVLH Instructions D'installation page 35

Installation Instructions - Dual Standard Installation
STEP 3 PREPARING UNIT FOR INSTALLATION - DUAL INSTALL
Unpack the heater Unification Kit (ZKMV) and make
sure all of the components on the list are included.
NOTE: Ensure the heater connector cord is toward the
top of the unit when installed.
Place the right hand unit in front of the installation
opening in a way that the unit is in front of the intended
installed location.
Install adhesive heater on the outside of the unit to the
left side of the case. Install heater 4" below the case
top. Heater should be centered front to back on the
metal case.
shown. Clean the side using rubbing alcohol to ensure
proper clip adhesion.
4"
Adhesive
Heater
NOTE: The heater installation is available only on the left
side of compatible models.
WARNING
Hazard.
To avoid the risk of electric shock, make
sure the power cord is not plugged into the wall outlet.
AVERTISSEMENT
d'électrocution.
Pour prévenir le risque
d'électrocution, assurez-vous que le cordon électrique
n'est pas branché dans la prise murale.
ADVERTENCIA
Si no se siguen estas instrucciones, se podrá producir
la muerte, incendios o descargas eléctricas.
31-1000708 Rev. 0
Clips
Electrical Shock
Risque
Riesgo de Descarga
Install the transformer into the case top assembly:
1. Remove cover top by removing eight #8 hex screws
and keep aside for assembling back the cover top.
2. Place the transformer provided in ZKMV kit onto the
case top. Secure transformer with (1/4") hex screw
to case top in existing hole at the rear right side of
the top control housing.
3. Connect the 2 pin transformer connector to the
heater connector and 3 pin connector to panel
control, make sure locking tabs are engaged.
4. NOTE: Verify the master switch is on.
5. Assemble the cover top with screws save from
previous step.
Plug 2 position heater
connector to 2 position
transformer connector with
blue and yellow wires.
Control
Housing
Master Switch
Plug 3 position transformer connector with
black and white wires to 3 position harness
connector with brown and orange wires.
Enclosure assembly above is shown with cover
removed.
35
Remove empty
Screw hole
connector housing
location for
before connecting
transformer.
transformer.
Transformer