Monogram ZIC363IPVLH Instructions D'installation page 27

Installation Instructions - Single Integrated Installation
STEP 6 LEVEL UNIT
All models have 4-point leveling. The front is supported
by leveling legs; the rear is supported by adjustable
wheels. Both are accessible from the front of the unit.
To level the back of the unit, turn the 7/16" hex nut
located above the front leveling legs. Turn clockwise
to raise or counterclockwise to lower the unit.
leveling leg or a 7/16" open-end wrench at the bottom
of the leveling leg.
opening 84". The unit should be level and plumb with
cabinetry.
7/16" hex nut
adjusts rear
wheels
T30 bit
adjusts front
leveling legs
NOTICE: The rear leveling wheels and front leveling
legs are limited to a maximum height adjustment of 1".
If the installation requires more than 84" height, the
installer should elevate the unit on a sheet of plywood
or runners. Cabinetry trim could also be added across
the top of the opening to shorten the opening. If you
attempt to raise the unit more than 1", you will damage
the front leveling legs and the rear leveling wheels.
31-1000708 Rev. 0
7/16" open end wrench
adjusts front leveling legs
STEP 7 FINAL EXTERNAL UNIT
PREPARATION
FOR FLUSH INSTALLATION:
of the door is 3/4" behind front face of surrounding
cabinets BEFORE securing brackets to the surrounding
cabinetry.
Open the doors to
the units. Locate
removal tool. Filter
should be as shown.
counterclockwise
tool if needed).
remove. NOTE: Water
system will not function
Predrill 1/16" holes is both the sides of the surround
1/2" deep through holes in the enclosure.
Secure unit by driving four 1/4" hex screws to both
sides to surrounding cabinetry. NOTE: This step does
NOT replace the anti-tip safety hardware. Refer to
Step 4 Installing Anti-Tip Bracket and Step 7 Inserting/
Securing into Cabinet Surround for details on installing
the anti-tip hardware. Repeat for the second unit.
Locate blue arrow on
align arrow as shown.
turn clockwise (use
mounting hook.
Close the compartment door.
27
Make sure front surface
Compartment Door
Filter Removal
Tool
Mounting Hook
1/4" Hex Screws
Filter