Monogram ZIC363IPVLH Instructions D'installation page 57

Installation Instructions - Dual Integrated Installation
STEP 9 FINAL EXTERNAL UNIT
PREPARATION (Cont.)
the doors/drawers and push the flexible "dart" in the
area between units.
bottom edge of the case trim. NOTE: Align dart
correctly before pressing in. Dart will be very difficult
to move once pressed in all the way.
center covers.
Open both enclosure doors to 90°.
Snap the trim bracket between the water filter access
enclosures above displays.
31-1000708 Rev. 0
Top
"Dart"
"Dart"
Mullion
Trim
NOTE: Doors/Drawers not
shown for clarity.
STEP 9 FINAL EXTERNAL UNIT
PREPARATION (Cont.)
If installation requires a
limiter pin(s) must be installed
- Open the door to expose the hole in the back hinge
bracket and install the limiting pin. Pin must be
fully seated in the hinge or the door will not close
properly.
STEP 10 TOE KICK INSTALLATION
Create a custom toe kick or purchase Stainless Steel
Toe Kick ZKN72V.
Remove the toe kick magnets from the front access
covers. These will be used for custom toe kicks only.
For custom toe kicks, adhere magnets to the back
side of the toe kick. The surface of the toe kick where
the magnets are to be placed must be clean and free
of foreign material. Center magnets vertically and
horizontally.
Position toe kick on bottom portion of front access
covers.
Dual Integrated Custom Toe Kick Dimensions
Thickness No greater than 3/4" (1.9 cm)
Width 71 7/8" (182.6 cm)
Height Determine after product is leveled
in installation space
57
90° door opening, the hinge
in the top hinge(s).