Monogram ZIC363IPVLH Instructions D'installation page 33

Installation Instructions - Dual Standard Installation
KIT ZKMV PARTS SUPPLIED:
Adhesive Heater
Transformer
Front Mullion
Trim Bracket
Top Unification Bracket
Bottom Front Unification Bracket
Bottom Back Unification Bracket
3 1/4" Hex Head 8-18 5/8" Long Screws
5 1/4" Hex Head 8-32 5/8" Long Screws
5 3/8" Hex Head 1/4-20 1/2" Long Screws
4 wire clips
STEP 1 REMOVE PACKAGING
WARNING
appliance is top heavy. Use extreme caution with
moving to prevent tipping over which could result in
death or serious injury.
AVERTISSEMENT
basculement.
Cet électroménager est lourd du haut.
Usez d'extrême prudence en le déplaçant afin de prévenir
un basculement susceptible d'occasionner des blessures
graves ou la mort.
ADVERTENCIA
Este electrodoméstico es inestable. Tenga extremo
cuidado al moverlo, a fin de evitar caídas hacia adelante
que podrían resultar en la muerte o lesiones graves.
Remove outer carton and external packing from units.
the refrigerator. These parts will be used during the
door panel installation.
Inspect for damage.
Ensure the flooring that the units are set is clean/
free of debris that could be collected on to, or
pinched in front of the wheels and damaging the
floor. Additionally, it is recommended that the floor
be protected with a plastic covering through out the
installation process.
31-1000708 Rev. 0
Tip Over Hazard.
This
Risque de
Riesgo de Caída.
STEP 1 REMOVE PACKAGING
(Cont.)
Remove hardware kit from convertible drawer.
Remove front access cover from unit by removing
two 1/4" Hex Screws. Place the cover and screws to
the side for future
Remove two 3/8" drive screws and two 7/16" drive
screws from each side of the unit to release it from
the shipping skid. Tip the unit from the side enough
to remove the shipping material from under the unit,
but above the shipping skid (both sides)
CAREFULLY roll the unit off the back side of the
shipping skid.
Handle from side only with a hand truck.
3/8" Drive
Screws
Shipping
Bracket
7/16" Drive
Screws
33
installation.
1/4" Hex Screws