Monogram ZIC363IPVLH Instructions D'installation page 12

Installation Instructions - Single Standard Installation
STEP 2 INSTALL WATER LINE
(Cont.)
NOTE: Saddle type shut-off valves are not
recommended but are included in many water supply
kits. Before purchasing, make sure a saddle type valve
complies with your local plumbing codes.
NOTE: Commonwealth of Massachusetts Plumbing
Codes 248CMR shall be adhered to. Saddle
valves are illegal and use is not permitted in
Massachusetts. Consult with your licensed plumber.
Route 1/4" OD copper or SmartConnect™
(WX08X10006) plastic tubing between house cold
water line and the water connection location at the
front of the unit.
Tubing should be long enough to extend to the front
of the unit. Allow enough tubing to accommodate
bend leading into the water line connection.
NOTE: The only Monogram approved plastic tubing is
supplied in the SmartConnect
Do not use any other plastic water supply line because
the line is under pressure at all times. Other types of
plastic may crack or rupture with age and cause water
damage to your home.
The waterline will be taped to the floor using masking
tape after anti-tip bracket installation.
STEP 3 INSTALL ANTI-TIP
BRACKETS
WARNING
These appliances are top heavy, especially with
any doors open, and must be secured to prevent
tipping forward which could result in death or seri-
ous injury. Read and follow the entire installation
instructions for securing the appliance with the
anti-tip system.
AVERTISSEMENT
basculement.
Ces électroménagers sont lourds du
haut, notamment lorsqu'une porte est ouverte, de sorte
qu'ils doivent être fixés pour prévenir un basculement
vers l'avant susceptible d'occasionner des blessures
graves ou la mort. Lisez et observez la totalité des
instructions d'installation pour connaître la façon de fixer
l'électroménager sur le dispositif antibasculement.
™ Refrigerator Tubing kits.
Tip Over Hazard.
Risque de
STEP 3 INSTALL ANTI-TIP
BRACKETS (Cont.)
ADVERTENCIA
Caídas
Estos electrodomésticos son inestables, espe-
cialmente cuando una puerta se encuentre abierta, y
deben estar asegurados a fin de evitar caídas hacia
adelante que podrían resultar en la muerte o en lesiones
graves. Lea y siga las instrucciones de instalación en su
totalidad para asegurar el electrodoméstico con el siste-
ma anti volcaduras.
Remove the anti-tip bracket(s) from the hardware kit
located in the convertible drawer.
Secure anti-tip brackets to the floor so that the back
side of the anti-tip bracket is 23" (58.4 cm) from the
front of the enclosure (bracket hardware is provided
for mounting into wood and concrete).
Measure and mark from the right side of the opening
per the dimensions shown.
Mount the anti-tip bracket centered about the marks
and flush to the floor as shown. Mark 3 holes for wall
mounting or 4 holes for floor mounting.
WOOD MOUNTING: Predrill with 3/16" drill bit, 2"
deep, then install lag bolts with a 3/8" driver.
CONCRETE MOUNTING: Predrill with a 5/32"
concrete bit, 2" deep, then install tapcon screws with
a 5/16" driver.
The bracket must be screwed to either the FLOOR or
REAR WALL.
Tape the waterline to the wall and floor as shown
below. Waterline should be 10" (25.4 cm) away from
adjacent wall. Apply tape about every 5" (12.7 cm)
toward front of unit. This will keep the waterline away
from the anti-tip bracket(s) and prevent the unit from
rolling over the waterline during installation. Do not
tape near the cabinet front in order to keep tape
hidden under the
unit.
12
Riesgo de
6"
(15.2 cm)
29-3/4" (75.6 cm)
5"
10"
31-1000708 Rev. 0