Monogram ZIC363IPVLH Instructions D'installation page 43

Installation Instructions - Dual Standard Installation
STEP 11 FINAL EXTERNAL UNIT PREPARATION (Cont.)
Put the access cover back onto the unit and secure with
two 1/4" hex head screws.
Access
Cover
of the installation, drive two 1/4" hex head screws.
These screws will enhance attachment of mullion trim.
Repeat on the second access cover.
Access Cover
Hole Locations
Install front mullion trim between the two units. Open
Doors and push the flexible dart in the area between
units.
edge of the case trim. NOTE: Align dart correctly
before pressing in. Dart will be very difficult to move
once pressed in all the way.
covers.
31-1000708 Rev. 0
1/4" Hex
Screws
Open both water filter access doors to 90°.
Snap the trim bracket
between the water fil-
ter access enclosures
above displays.
If installation requires
a
the hinge limiter pin(s)
must be installed
the top
- Open the door to
43
90° door opening,
in
hinge(s).
expose the hole in
the back hinge bracket and install the limiting pin. Pin
must be fully seated in the hinge or the door will not
close properly.
"Dart"
Mullion
Trim
NOTE: Doors/Drawers not
shown for clarity.
Top
"Dart"