Monogram ZIC363IPVLH Instructions D'installation page 56

Installation Instructions - Dual Integrated Installation
STEP 9 FINAL EXTERNAL UNIT
PREPARATION
FOR FLUSH INSTALLATION:
of the door is 3/4" behind front face of surrounding
cabinets BEFORE securing brackets to the surrounding
cabinetry.
Compartment Door
Open the doors to
Filter Removal
the units. Locate
Tool
removal tool. Filter
should be as shown.
counterclockwise
needed).
remove. NOTE: Water
system will not function
Predrill 1/16" holes is both the sides of the surround
1/2" deep through holes in the enclosure.
Secure unit by driving four 1/4" hex screws to both
sides to surrounding cabinetry. NOTE: This step
does NOT replace the anti-tip safety hardware. Refer
to Step 4 Installing Anti-Tip Bracket and Step 7
Inserting/Securing into Cabinet Surround for details
on installing the anti-tip hardware. Repeat for the
second unit.
1/4" Hex Screws
Locate blue arrow on
align arrow as shown.
removal tool if needed).
mounting hook.
Close the compartment door.
Make sure front surface
Filter
Mounting Hook
STEP 9 FINAL EXTERNAL UNIT
PREPARATION (Cont.)
Put the access cover back onto the unit and secure
with two 1/4" hex head screws.
Access
Cover
On the side of the access cover that will face the middle
of the installation, drive two 1/4" hex head screws. These
screws will enhance attachment of mullion trim. Repeat
on the second access cover.
Access Cover
Hole Locations
56
1/4" Hex
Screws
31-1000708 Rev. 0