Monogram ZIC363IPVLH Instructions D'installation page 44

Installation Instructions - Dual Standard Installation
STEP 12 TOE KICK INSTALLATION
Create a custom toe kick or purchase Stainless Steel
Toe Kick ZKK72R.
Remove the toe kick magnets from the front access
covers. These will be used for custom toe kicks only.
For custom toe kicks, adhere magnets to the back
side of the toe kick. The surface of the toe kick where
the magnets are to be placed must be clean and free
of foreign material. Center magnets vertically and
horizontally.
Position toe kick on bottom portion of front access
covers.
Dual Standard Custom Toe Kick Dimensions
Thickness No greater than 3/4" (1.9 cm)
Width 71 3/8" (181.3 cm)
Height Determine after product is leveled
in installation space
STEP 13 INTERNAL UNIT
PREPARATION
Remove all tape, cardboard, and foam from each
unit.
Remove boxed door bins from shelves.
Unbox and install door bins.
Install door bin mats.
Install Odor filter and Fresh filter (some models).
See Owner's Manual for details.
STEP 14 START ICEMAKER
CAUTION
To minimize the risk of personal
injury, avoid contact with the moving parts of the
ejector mechanism, or with the heating element that
releases the cubes. Do not place fingers or hands on
the automatic ice making mechanism while the
appliance is plugged in.
STEP 14 START ICEMAKER (Cont.)
ATTENTION
évitez tout contact avec les pièces mobiles du mécanisme
d'éjection ou l'élément chauffant qui libère les cubes. Ne
placez pas les doigts ou les mains sur le mécanisme de
production de glace automatique lorsque l'électroménager
est branché dans la prise électrique.
PRECAUCIÓN
lesiones personales, evite el contacto con las partes móviles
del mecanismo eyector o con el elemento de calefacción
que libera los cubos. No coloque los dedos ni las manos en
el mecanismo de la máquina de hielo automática mientras
el electrodoméstico se encuentre enchufado.
A newly-installed freezer may take 12–24 hours to
begin making ice.
The icemaker will produce seven cubes per cycle—
approximately 15 cycles in a 24-hour period,
depending on freezer compartment temperature, room
temperature, number of door openings and other use
conditions.
If the freezer is operated before the water connection
is made to the icemaker, turn the ice maker off by
pressing and holding the Zone Select pad until Ice Off
appears.
When water has been connected
to the water supply, turn the
ice maker on by pressing and
holding the Zone Select pad
until Ice On appears.
Throw away the first full bucket
of ice to allow the water line to
clear.
Be sure nothing interferes with the sweep of the feeler
arm.
When the bin fills to the level of the feeler arm, the
icemaker will stop producing ice.
It is normal for several cubes to be joined together.
If ice is not used frequently, old ice cubes will become
cloudy, taste stale and shrink.
NOTE: Icemaker works best between 40 and 120 PSI
(275-827 kPa) home water pressure.
44
Afin de réduire le risque de blessure,
Para minimizar el riesgo de
(Appearance may vary)
Feeler Arm
31-1000708 Rev. 0
Icemaker