Hürner HST 300 HP 2.0 Manuel Utilisateur page 40

then be accessed by pressing the ò arrow key. The screen
will show a menu as reproduced in Display 12, provided
manual input is enabled in the configuration menu (see
Sect. 10.1). In other words, the manual parameter input
replaces reading the bar code of the fitting with a scanner.
Using the arrow keys ñ and ò you can select "Enter Volt-
age/Time" or "Enter Fitting Code" (i.e., the numbers that
represents the code of the fitting to be used). Confirm your
selection by pressing the START/SET key.
7.1 Manually Entering Welding Voltage and Time
If this option was chosen in the manual parameter input
menu, a display like the one to the right appears on the
screen. Use the alphanumeric keypad (see Info in Sect. 5.2)
to set the welding voltage and the welding time, accord-
ing to the fitting manufacturer's instructions, then press
the START/SET key to confirm your input. The "Start ?"
message displayed after the confirmation by START/SET
indicates that the unit is ready for welding.
7.2 Entering the String of Numbers
If this option was chosen in the manual parameter input
menu, the "Enter Fitting Code" display shows. The 24 char-
acters of the fitting code to be entered display as asterisks
( * ). Use the alphanumeric keypad (see Info in Sect. 5.2)
to enter the code and press START/SET to confirm your
input and have it decoded. If the code entered is not cor-
rect, an "Input Error" message appears; check the string
of numbers and correct as needed. If the code is correct,
the decoded data is displayed, and the "Start ?" message
indicates that the unit is ready to start welding.
8 Downloading the Reports
Interface
USB A Interface Port
for connecting USB mass storage media (such as a
memory stick)
The interface port complies with the USB version 2.0
specification (i.e., maximum data rate of 480 megabits
per second).
Before transferring data, it is highly recommended
to switch the welding unit off and on again. If this
fails to happens, there is a risk of data transfer
Important
16
EN
HÜRNER HST 300 HP 2.0 User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Voltage/Time
U= 40 V
Version September 2022
t= 1000 s
Display 13