Hürner HST 300 HP 2.0 Manuel Utilisateur page 33

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
e.g., pipe and fitting traceability codes. To use this feature,
the desired data have to be enabled in the configuration
menu, at "Recording" (see Sect. 10.2).
The welding parameters can also be entered manually. The
microprocessor-controlled HST 300 HP 2.0 Welding Unit
• controls and monitors the welding process in a fully
automated fashion,
• determines welding duration depending on ambient
temperature,
• shows all information on the display in plain text.
All data that are relevant for the weld or for traceability
are saved to the internal memory and can be sent to a
USB stick.
Welding data transfer is enabled through an interface of
the USB A type, which is compatible with a USB stick.
Further Optional Accessories
• PC software for downloading and archiving data on
PC (for all common Windows operating systems)
• Label tag printer for printing an identifier label for
the new joint right after the welding operation
• USB stick for data transfer from the welding unit on
the worksite to the printer or PC in your office (see
details at the end of this booklet)
5 Check-out and Operation
• To operate the welding unit, be sure that it is set on a
proper, level surface.
• Be sure that power supply/generator protection is ad-
equate.
• Plug the power supply cord into the mains power
supply or the generator.
• Read and comply with the User's Manual of the gen-
erator, if applicable.
5.1 Turning the Welding Unit on
After connecting the power supply cable to mains power
or a generator, turn the welding unit on using the On/Off
switch. This causes Display 1 to show.
Then the screen changes to Display 2.
CAUTION in case of System Errors!
If during the auto-test that the unit performs at
start-up, an error is detected, a "System Error" mes-
Caution
Version September 2022 HÜRNER HST 300 HP 2.0 User's Manual
********************
HUERNER
HST300 HP 2.0
********************
Display 1
Enter Fitting Code
14:32:11 21.10.12
Inp.Volt. 400V 50Hz
No Contact
Display 2
EN
9