Publicité
Les langues disponibles
Les langues disponibles
■ When there is a problem with the lamp
z
The status of the indicator is displayed with the following symbols.
L: Off, G: On, #: Flashing, I: On or Flashing
Indicator
<STAND-
<WARNING
<POWER>
BY>
TEMP.>
Green
Red
Red
*1
*1
*1
I
I
I
*1
*1
*1
I
I
I
*1
*1
*1
I
I
I
*1: The indicator will change according to different conditions, regardless of the status of other indicators.
*2: The indicator will flash in approximately 0.5-second intervals.
*3: The indicator will flash in approximately 2-second intervals.
Note
z The status of each lamp can be checked as the lamp indicators (<LAMP 1 REPLACE> to <LAMP 4
REPLACE>) at the top of the projector turn on or flash. (
LX1750 User Manual
020-000638-01 Rev.1 (11-2013)
All manuals and user guides at all-guides.com
<WARNING
<LAMP
<SHUTTER>
FILTER>
REPLACE>
Blue
Orange
Orange
*1
*1
*2
I
I
#
*1
*1
*3
I
I
#
*1
*1
I
I
G
About indicator status
Status of the projector
Either of the lamps do not turn on. (The lamp is cooling
down. After the standby indicator <STAND-BY> turns
on again, press the power <ON> button on the remote
control or the power<ON/STAND-BY> button on the
control panel.)
Either of the lamps do not turn on. (The lamp has
cooled, and returned to operating temperature.
Pressing the power <ON> button on the remote
control or the power <ON/STAND-BY> button on the
control panel will make the indicator stop flashing and
operate the projector.)
The recommended time to replace the lamp has been
reached.
The
will be displayed at the top right of the screen
to notify the user of replacement.
Replace the lamp unit as soon as possible. Replacing
the lamp will cause the lamp indicator <LAMP
REPLACE> to turn off.
page 85)
ENGLISH - 81
Publicité
