Christie LX1750 Mode D'emploi page 69

[Setting] menu
[Power management]
1) Press ▲▼ to select [Power
management].
2) Press the <SELECT> button.
z
z The sub menu 2 is displayed.
3) Press ▲▼ to switch the setting.
Cancels the power management
[Off]
function.
Turns off the lamps and starts
cooling when the time set using
[Timer] has elapsed. While lamp is
being cooled, the standby indicator
<STAND-BY>, and the power
indicator <POWER> are flashing,
you cannot operate the projector.
When lamp cooling has finished,
the power indicator <POWER>
[Ready]
continues flashing and the standby
indicator <STAND-BY> lights up
instead of flashing, indicating that
the projector is now in the power
management mode.
From this point, if a signal is input
or operations are performed on the
projector, the lamps will turn on and
the projection will start.
Turns off the lamps and starts
cooling when the time set using
[Timer] has elapsed. During lamp
[Shut down]
cooling, you cannot operate the
projector.
When lamp cooling has finished,
the power will turn off.
[Timer] Sets times from 1 - 30 minutes.
Note
z The factory default setting is [Off].
z The power management function cannot be used
when the freeze function (
function ( page 37) is in use.

z When the power management function is started,
[P-timer] is reset.
68 - ENGLISH
All manuals and user guides at all-guides.com
page 37) or shutter

[Direct on]
This is a function for automatically switching on
the power of the projector when the power cord is
connected, without requiring operations on the power
<ON> button on the remote control or the power <ON/
STAND-BY> button on the control panel.
1) Press ▲▼ to select [Direct on].
2) Press the <SELECT> button.
z ▲▼ are displayed over the sub menu 2. z
3) Press ▲▼ to switch the setting.
[Off]
Enables normal operations to turn
[Off]
on/off the power.
Allows power to be turned on
[On]
directly.
Note
z Be sure to turn on/off the power using the correct
operations.
z Pressing the power <ON> button on the remote
control or the power <ON/STAND-BY> button on
the projector will not turn on the power until the
lamp cooling has finished and the lamps are ready
to be turned on again.
[On]
LX1750 User Manual
020-000638-01 Rev.1 (11-2013)