Christie LX1750 Mode D'emploi page 71

[Setting] menu
■ [PIN code change] z
Changes the logo PIN code.
1) Select [PIN code change], and press
the <SELECT> button.
z
z The PIN code input screen is displayed.
2) Press ▲▼◀▶ or the number (<0> -
<9>) buttons to enter the PIN code.
3) Press ▲▼◀▶ to select [Set].
4) Press the <SELECT> button.
z
z If the PIN code is accepted, the new logo PIN
code is displayed on the screen.
5) Press ▲▼◀▶ or the number (<0> -
<9>) buttons to set your new PIN code.
6) Press the <SELECT> button.
7) Select [Yes], and press the <SELECT>
button.
z
z If the PIN code is accepted, the projector
returns to the sub menu 2.
Note
z To re-enter a number, press ◀▶ to select the digit
to re-enter, then press ▲▼ or the number (<0> -
<9>) buttons to re-select the number.
z Move the cursor to [Cancel] and press the
<SELECT> button to return to the sub menu 2.
[Projector ID]
Sets the projector ID (1 to 64) for the RS-232C serial
communication.
1) Press ▲▼ to select [Projector ID].
2) Press the <SELECT> button.
3) Press ▲▼ to select an item.
z
z The factory default setting is [ALL].
Makes projector accept operations
regardless of any ID number
[ALL]
specified by the remote control or
PC.
Sets ID numbers from 1 - 64 to the
1 - 64
projector.
70 - ENGLISH
All manuals and user guides at all-guides.com
[Shutter]
Sets the shutter function.
1) Press ▲▼ to select [Shutter].
2) Press the <SELECT> button.
z
z The sub menu 2 is displayed.
3) Press ▲▼ to select an item.
■ [Protection] z
Locks the button to prevent shutter operations.
1) Select [Protection], and press the
<SELECT> button.
z ▲▼ are displayed over the sub menu 2. z
2) Press ▲▼ to select an item.
z
z The setting will change as follows each time
you press the button.
Protection is off.
Operation can be made from both
the remote control and projector.
Locks operations from the remote
control.
Locks operations from the control
panel.
Locks operations from both the
remote control and the control panel.
LX1750 User Manual
020-000638-01 Rev.1 (11-2013)