Christie LX1750 Mode D'emploi page 61

[Setting] menu
[Background]
Selects the background screen when there is no input
signal.
1) Press ▲▼ to select [Background].
2) Press the <SELECT> button.
z ▲▼ are displayed over the sub menu 2. z
3) Press ▲▼ to select an item.
z
z The setting will change as follows each time
you press the button.
[Blue]
[Lamp select]
Selects the lamp used for projection.
1) Press ▲▼ to select [Lamp select].
2) Press the <SELECT> button or ▶ .
z
z The sub menu 2 is displayed.
3) Press ▲▼ to select.
z Press ◀ to return to the sub menu. z
■ [4-Lamps] z
Turns on four lamps.
1) Select [4-Lamps], and press the
<SELECT> button.
2) Select [Yes], and press the <SELECT>
button.
z
z The setting ends and the projector returns to
the sub menu 2 screen.
z
z Select [No] and press the <SELECT> button to
return to the sub menu 2.
■ [2-Lamps] z
Turns on two lamps.
1) Select [2-Lamps], and press the
<SELECT> button.
2) Select [Yes], and press the <SELECT>
button.
z
z The setting ends and the projector returns to
the sub menu 2 screen.
z
z Select [No] and press the <SELECT> button to
return to the sub menu 2.
Automatically detects the lamp with
[Auto] the shortest total time, and prioritizes
to turn it on.
Turns on lamp 2 and lamp 3.
Turns on lamp 1 and lamp 4.
60 - ENGLISH
All manuals and user guides at all-guides.com
[User] [Black]
Note
z If a lamp fails as a result of a fault or reaching the
end of its service life, the lamp indicator <LAMP
REPLACE> on the front of the projector body and
the lamp indicator (<LAMP 1 REPLACE> - <LAMP
4 REPLACE>) on the projector body above the
failed lamp will flash. An X mark will also appear as
the lamp status at the top of the screen.
z When [4-Lamps] is selected and one lamp fails, two
diagonally opposed lamps (not including the failed
lamp) perform the projection.
If a further lamp fails, the projection will continue
with one lamp.
z When [2-Lamps] is selected and one lamp fails, two
diagonally opposed lamps (not including the failed
lamp) perform the projection.
If a further lamp fails, the projection will continue
with one lamp.
z If all the lamps fail, the power will switch off. If the
power is turned on without replacing the lamps
after the duration exceeds 2 200 hours of usage
for all lamps, the power automatically turns off
after approximately ten minutes to prevent the
malfunction of the projector.
[Lamp power]
Sets switching of lamp brightness.
Using the eco mode is recommended if you want to
reduce power consumption.
1) Press ▲▼ to select [Lamp power].
2) Press the <SELECT> button.
3) Press ▲▼ to select an item.
z
z The setting will change as follows each time
you press the button.
Sets the brightness automatically
using a light-metering circuit.
(Auto)
Operates in certain brightness.
(Standard)
The air intake/exhaust decreases
compared to
(Eco mode 1) the fan becomes lower.
The air intake/exhaust increases
in comparison to
becomes louder.
(Eco mode 2)
, and the sound of
, and the fan
LX1750 User Manual
020-000638-01 Rev.1 (11-2013)