Install Glassware Set G3 - Heidolph LABOROTA 4000eco Mode D'emploi

E
6

Install glassware set G3

view fig. 1,5,7
Raise lift.
Unscrew coupling ring (12) from drive head and remove cocking spring (13). Slide
coupling ring (12) over condenser flange (K).
Slide cocking spring (13) over the flange as well. Screw condenser (K) on drive head with
coupling ring (12), pressing flange against PTFE seal 26 (11).
Arrange condenser clamp (7) on condenser (K) and secure on column (3) with clamp
screws. Match column (3) tilt to condenser (K). For more details about installation of
condenser holder, refer to page 31.
fig. 7
*
location of drip ring
Cooling water is connected with studs (W), hose fitting (H) and threaded cap (G).
Collecting flask (N) is secured on condenser (K) with a clamp (O). The flask clamp (O) is
secured in place by turning the knurled-head screw clockwise. Connect evaporator flask
(P) with vapor tube 26 (8); use clamp (Q).
The inlet pipe (M) is inserted into the ground glass stud on the left of the condenser. When
doing this connection, make sure drip ring is located on the PTFE tube as to prevent
condensate from flowing back into evaporator flask (P).
47