Heidolph LABOROTA 4000eco Mode D'emploi page 49

E
Insert supplied inlet tube (S) through cap (E) and washer (D) mounted on inletcock.
Secure tube by turning cap clockwise.
Locate gasket (X= silicon with FEP, or X1= silicon) in sealing groove of cold trap shroud
(K). Insert centering ring (B) in cold trap shroud (K) and insert cold trap (Y) in cold trap
shroud (K).
Connect vacuum sourcewith stud (V), connector (H) and threaded fitting GL 14 (G).
A
H
G
Y
V K
M
B
D
X/X1
E
Q
S
8
O
P
N
fig. 8
49