Safety Information; Set-Up - Heidolph 1000 Mode D'emploi

Please comply with all safety and accident-prevention regulations as in force
for laboratory work!
Use extra care when working with flamable substances; refer to safety data
sheets.
Use extra care when working in the vicinity of flamable and explosive
substances. Motors are of non-sparking type, the item itself however is not
explosion-proof.
When connecting your item with your local power supply, please make sure
your item is designed for your local voltage; go by the data plate on the item.
Please connect your item with a protective-ground outlet only.
Turn your power switch OFF whenever the item is not used, or before
disconnecting the plug.
Repair work is limited to technicians approved by Heidolph Instruments.
Your item needs a solid stand.
Lab bench needs to be of rigid design, and features an anti-skid surface coat.
Before starting the item, make sure all samples are attached safely (must not
move while shaking).
The INCUBATOR 1000, consists of heater module and hood; it may be combined with
shakers and mixers as stipulated below. The incubator heats fluids in whatever sort of vessel
during shaking. The hood is made of clear plastic material to allow watching of vessels
during shaking.
The INCUBATOR 1000 may be combined with shakers and mixers stipulated below:
TITRAMAX 1000
UNIMAX 1010
PROMAX 1020
DUOMAX 1030
POLYMAX 1040
Preparing shakers and mixers for use with / without the incubator can be done in a few steps
and will take only a few minutes.

SAFETY INFORMATION

SET-UP

17
E