Burkert BVS 14 ATEX E 008 X Instruction Supplémentaire page 7

BVS 14 ATEX E 008 X / E 052 X
Particularsafetyinstructions
▶ Close all unnecessary cable glands with lock screws approved
for the explosions area.
▶ The required degree of protection (min. IP64) is only guaranteed in
connection with suitable adaption sets. All pneumatic and electrical
connections must be equipped with suitable connectors.
4.1 instructions on operation in an
explosion-risk (Ex) area
4.1.1 Safety instructions
For operation in an explosion-risk area zone (gas) 1 and 2, the fol-
lowing applies:
Danger!
risk of explosion caused by electrostatic charge.
In the event of a sudden discharge from electrostatically charged
devices or individuals, there is a risk of an explosion in the
explosion-risk area.
▶ Take suitable measures to ensure that no electrostatic discharges
can build up in the explosion-risk area.
▶ Clean the device surface by gently wiping it with a damp or anti-
static cloth only.
4.1.2 media in explosion-risk areas
If explosive media are used, this can result in additional
explosion risks.
4.1.3 Actuators / valves in explosion-risk
areas
Use in an explosive atmosphere may be restricted by the
actuators / valves. Observe the operating instructions of the
actuators / valves.
4.1.4 cleaning in explosion-risk areas
Check that any cleaning agents are approved for use in
explosive atmospheres.
4.1.5 Adhesive signs for explosion-risk
areas
sign
Fig. 2: Sign
English
7