Burkert BVS 14 ATEX E 008 X Instruction Supplémentaire page 5

BVS 14 ATEX E 008 X / E 052 X
Authorizeduse
3 AuThorizEd uSE
incorrect use of the control unit can be dangerous to people,
nearby equipment and the environment.
▶ The device is designed to be mounted on pneumatic actuators
of process valves for the control of media.
The device was designed for the use in:
- type 8690 PX16
Explosion group II, category 2G Ex ia, T* and
explosion group II, category 2D Ex ia, IP64, T135°C
- type 8690 up to 8696 and 8798 PX03
Explosion group II, category 3G Ex nA, T4 and
explosion group II, category 3D Ex tc, IP65/67, T135°C
(see information listed on the sticker for the approval).
▶ The device is mounted onto a pneumatic actuator of a process
valve. The process valve and the actuator must have at least the
Ex approval of the control unit.
▶ During use observe the admissible data, the operating condi-
tions and conditions of use specified in the contract documents,
operating instructions and on the type label
- of the control unit and
- the process valve.
▶ Use the device only in conjunction with third-party devices and
components recommended and authorized by Bürkert.
▶ Correct transportation, storage and installation, as well as care-
ful use and maintenance are essential for reliable and faultless
operation.
▶ Use the device only for its intended purpose.
3.1 restrictions
If exporting the system/device, observe any existing restrictions.
3.2 identification (V code) PXxx
The identification (V code) PX03 or PX16 is on the type label of the
device.
8690
single act
Pmax 7bar
Tamb -10°C - 55°C
S/N 1001
00204194
Fig. 1: Example of type label
English
V-Code
PX16 Ex-i
pilot 3.0
2 sw. nam.
ce
W14UN
5