General Dynamics SIMUNITION FX 9004 Guide D'utilisation page 6

®
Donning the FX Hard Top Cover (8971805SP)
®
1. The FX Hard Top Cover (see Fig. 7 and 8) comes with 8 circular, self-adhesive foam pads, not installed (see Fig. 9).
Fig. 7 – Hard top cover
2. Prior to using your Hard-Top Cover, install four (4)
circular foams at the marked spots located in the interior
®
of your FX Hard Top Cover (see Fig. 8).
3. Hold your Hard-Top Cover with your hands, look inside,
and you should see the word ''FRONT'' engraved on the
brim of your Hard-Top Cover (see Fig. 10).
4. Start by locating the center of your hard-top cover and
place the front (brim) centered above the lens (see Fig.
11).
5. Flip the Hard-Top Cover over your head, ensuring that the brim on the front of the Hard-Top cover is centered on
the top of the FX
6. Apply pressure on the Velcro
on each side) to make sure that your hard-top cover is secured firmly over your FX
(see Fig. 12).
Fig. 11 - Hard Top Cover flipping
© 2022 General Dynamics-OTS Canada
®
9004 Helmet, Head Protector (see Fig. 11).
®
fastener hook and loop with the help of your hands (1 located on front and 1 located
Registered trademarks of General Dynamics Ordnance and Tactical Systems-Canada Inc. are denoted by
inside view
Fig. 8 – Hard top cover,
Front marking
www.simunition.com
Fig. 9 – Self-adhesive foam
Fig. 10 – Front (Brim) centered
®
9004 Helmet, Head Protector
Fig. 12 - Hard top cover firmly secured
.
®
Page 6 of 52
8972330.FTSIM_rev00