General Dynamics SIMUNITION FX 9004 Guide D'utilisation page 18

7. To install the stems of the Anti-Soap Baffle:
A) Insert the stem tip through the opening of the corresponding numbered grill (See Fig. 54 and 55).
B) Gently pull the stem using your fingers or a pair of tweezers (see Fig. 56) until you hear a clicking noise (see Fig.
57) which indicates that the stem has been installed properly in place.
C) Repeat this operation (A and B) for all stems.
Note: To ensure that all stems were properly inserted, with the help of your fingers, move the tip of the stem
from right to left (see Fig. 58 and 59). You should be able to see that the undercut lodgment located at the
base of the stem is properly adjusted and maintained at its place in the Face Shield opening.
Note: Some physical effort may be necessary to insert the stems into their openings.
8. To re-install the left and right ear foam parts, align the edge of the foam with the edge of the Face Shield. Then,
firmly press the foam against the Velcro
© 2022 General Dynamics-OTS Canada
Fig. 54
Fig. 57
®
Fig. 60 - Face Shield's ears foam alignment edges
Registered trademarks of General Dynamics Ordnance and Tactical Systems-Canada Inc. are denoted by
Fig. 55
Fig. 58
Hook with your fingers (see Fig. 60).
www.simunition.com
Fig. 56
Fig. 59
.
®
Page 18 of 52
8972330.FTSIM_rev00