General Dynamics SIMUNITION FX 9004 Guide D'utilisation page 11

®
Reassembly of FX
Cleaning)
1. Re-install the Ears (left and right) foam parts by aligning the edges of the foam with the edge of the Face Shield.
Then, press the foam firmly against the Velcro Dot Hook with your fingers.
2. Prior to re-installing the chin foam part, bend the chin foam with your fingers and join both ends together.
3. Align the bended center joint on the marked line, located on the Face Shield at the chin area (see Fig. 23).
4. Firmly press the chin foam against the Velcro Dot Hook with your fingers (see Fig. 24).
5. Similarly, bend the Forehead Foam with your finger and join both ends together (see Fig. 25).
© 2022 General Dynamics-OTS Canada
9004 Helmet, Head Protector after Cleaning as per Procedure 1 (Mask's Light
Fig. 21
Fig. 23 – Face shield marked
center line at the chin area
Registered trademarks of General Dynamics Ordnance and Tactical Systems-Canada Inc. are denoted by
Fig. 22 - Face shield's ears foam alignment edges
Fig. 25 - Center Velcro Hook dot at the forehead area
www.simunition.com
Fig. 24 -
.
®
Page 11 of 52
8972330.FTSIM_rev00